Petrology, Mineralogy and Geochemistry of the Beattie Syenite and Country Rocks, Abitibi Greenstone Belt, Quebec

The Beattie syenite is composed of a series of lenticular bodies of syenitic rocks, situated immediately north of the Porcupine-Destor fault zone in the town of Duparquet, approximately 32 km north of Rouyn-Noranda in the Abitibi Subprovince. The principal body is 3.3 km long and 470 m in width and is flanked by a series of smaller lenses to the south and northeast. The intrusion has been zircon dated at 2682+/-1Ma and 2682.9+/-1.1 Ma and hosted the major part of the Au-mineralization of the now defunct Beattie mine, which was an important producer of gold in the area from 1933 to 1956 (9.66 Mt at 4.88 g/t Au). A total of 5 petrographic units are defined here, on the basis of field relationships, macroscopic textures, petrology and mineralogy:;1- The porphyritic Beattie syenite unit is composed of 2% to 10% of tabular sub- to anhedral feldspar phenocrysts about 2 mm to 10 mm in size, set in a red feldspathic and aphanitic matrix. This unit can be strongly cataclastic with abundant hydrothermal minerals.;2- The equigranular magnetite-bearing syenite unit includes few feldspar phenocrysts, about 2 mm to 10 mm in a fine-grained matrix. It is characterized by unaltered titanite, epidote, hornblende porphyroblasts and is the only unit with actinolite replacing clinopyroxene.;3- The porphyritic Central Duparquet syenite unit contains between 2% - 25% of coarse equant euhedral feldspar phenocrysts, about 5 mm to 16 mm in size, in a red or sometimes grey aphanitic matrix.;4- The megaporphyritic syenite unit is composed of very coarse alkali feldspar phenocrysts, typically 1 cm to 6 cm across, in a red aphanitic matrix. The phenocrysts often form a glomeroporphyritic texture.;5- The lath syenite unit occurs as numerous ∼ m-width thin dykes, which cross-cut all other petrographic units. These dykes display a characteristic trachytic texture, as defined by the preferential alignment of alkali feldspar laths, which are typically 1 cm to 3 cm in a grey or red aphanitic matrix.;Petrology and geochemistry investigations revealed that the syenite intruded into the older 2720-2718 Ma volcanic Deguisier Formation and the <2687+/-2 Ma sediments of the Porcupine Group. Detailed geochemical analysis revealed that the Deguisier Formation is composed of three units, forming a complete tholeiitic suite. The Deguisier Formation is proposed here to have been produced in a volcanic arc setting.;Detailed petrological, mineralogical and geochemical studies indicate that, the syenite is part of the alkaline series and is metaluminous to peraluminous. The syenite intruded at shallow depths through a sequence of injections, yielding the five comagmatic units.;The syenite and country rocks were then subjected to a series of hydrothermal alterations and brittle deformation events, combined with metamorphism to the greenschist facies. The Au-mineralization in this region is attributed to the hydrothermal alteration with brittle deformation.