Measurement of the argon-38(n,2n)argon-37 and calcium-40(n,alpha)argon-37 cross sections, and National Ignition Facility concrete activation using the rotating target neutron source. The design of an experiment to measure the beryllium-9(n,gamma)beryllium

The Rotating Target Neutron Source (RTNS) was used in experiments to measure neutron induced cross sections at 14 MeV, and the activation properties of a specific mix of concrete. The RTNS is an accelerator based DT fusion neutron source located at the University of California, Berkeley.; Two of the experiments performed for this thesis were specifically of interest for the construction and operation of the National Ignition Facility (NIF), they were the 38Ar(n,2n)37Ar cross section measurement, and the concrete activation measurement.; The NIF is a large multi-beam laser facility that will study the effects of age on the nation's stockpile of nuclear weapons. The NIF, when fully operational, will focus the energy of 192 Neodymium glass lasers onto a 1 mm diameter pellet filled with deuterium and tritium fuel. This pellet is compressed by the laser energy giving some of the individual atoms of deuterium and tritium enough kinetic energy to overcome the coulomb barrier and fuse. The energy output from these pellet implosions will be in the range of tens of mega-joules (MJ).; The 38Ar(n,2n)37Ar reaction will be useful to NIF scientists to measure important parameters such as target energy yield and areal density. In order to make these measurements precise, an accurate 38Ar(n,2n)37Ar cross section was necessary. The cross sections measured were: 74.9 ± 3.8 millibarns (mb) at 13.3 ± 0.01 MeV, 89.2 ± 4.0 mb at 14.0 ± 0.03 MeV, and 123.57 ± 6.4 mb at 15.0 ± 0.06 MeV.; With anticipated energy yields in the tens of mega-joules per pellet implosion, the number of neutrons released is in the range of 1019 to 1020 neutrons per implosion. With such a large number of neutrons, minimizing the activation of the surrounding structure is very much of interest for the sake of personnel radiation safety. To benchmark the computer codes used to calculate the anticipated neutron activation of target bay concrete, samples were irradiated at the RTNS. Dose rates from each sample were recorded as a function of time after irradiation. These dose rates were compared to those calculated using the Monte Carlo code TART and the activation code ACAB. It was found that 95.8% of the comparisons agreed within the experimental uncertainty.; The 40Ca(n,α)37Ar reaction was of interest for the detection of clandestine underground nuclear detonations. Since calcium is naturally abundant in the earth's crust, and since 37Ar is an inert gas and is not found naturally, the 40Ca(n, α) 37Ar reaction is a good candidate for detecting a nuclear detonation. An accurate cross section is needed to estimate the yield of the nuclear device. The average cross sections measured were: 175.6 ± 9.2 millibarns (mb) at 13.2 ± 0.6 MeV and 122.1 ± 4.6 mb at 15.2 ± 0.12 MeV.; One of the current NIF pellet designs uses beryllium as the ablation layer, and the target positioner will be made of a beryllium/copper alloy. The reaction product, 10Be, from the 9Be(n,γ) 10Be reaction will be generated, although probably in very small quantities, during the lifetime of the NIF. This cross section has not been measured at 14 MeV, but should be measured to estimate the amount of 10Be produced at the NIF.