Font Size:
a
A
A
Keyword [Green Machining]
Result: 1 - 11 | Page: 1 of 1
1.
Study On Some Issues Of Cryogenic Cold Air Used In Green Machining
2.
Research On The Green High Speed Machining Of Titanium Alloy
3.
Study On The High Speed Milling Of Titanium Alloy Based On Cooled Gaseous Nitrogen And Minimal Quantities Of Lubricant Technology
4.
Experimental Investigation On Cold Air Cutting Technology In Green Machining
5.
Atomization Simulation And Experimental Research Of The Cutting Fluid Of Oils On Water
6.
The Analysis And Research Of Low-temperrature Cold Air Cutting Performance Of Hard Processing Materials
7.
Heat Pipe Cutter Design Preparation And Its Heat Dissipation Performance Analysis
8.
Study Of Low-temperature Cold Air Cutting Performance Of Typical Difficult-to-machine Materials
9.
Research On Green High-Efficiency Cutting Process Optimization And Its Intelligent Expert System
10.
Research On The Influence Of Cutting Parameters On Tool Wear And Surface Quality Under The MQCL Conditions And Evaluation Of Green Machining
11.
Research On Heat Dissipation Performance Of Heat Pipe Cutter For Green Machining
<<First
<Prev Next>
Last>>
Jump to
