Powder injection molding - Globe Thesis

Keyword [Powder injection molding] Result: 61 - 77 \| Page: 4 of 4
61.	Preparation And Application Of New Polyaldehyde Binder For Metal Powder Injection Molding
62.	Study On Preparation And Injection Molding Of Aluminum Nitride Powder
63.	Synthesis And Research Of Functionalized Polyacrylate Binder For Metal Powder Injection Molding
64.	Study On Properties And Application Of New Stellite Alloy Prepared By Metal Powder Injection Molding
65.	Titanium-based Y-PSZ/Ti Particle Reinforced Composite Research
66.	The Effect Of Low Melting Point SnPb Alloy Powder On The Structure And Properties Of HBP Modified PLA
67.	Gas-assisted powder injection molding: A comparison of residual wall thickness between metal cavity vs. SLA cavity and effect of mold temperature on residual wall thickness
68.	Gas-assisted powder injection molding: A study on the effect of processing variables on bubble formation
69.	The effects of process parameters on the shrinkage and tensile properties of stainless steel and the conductivity of graphite in powder injection molding
70.	Rapid tooling for powder injection molding
71.	Ultrasonic sensors for process control in powder injection molding
72.	Intelligent integrated diagnostics: Process monitoring and diagnosis for on-line quality control of powder injection molding
73.	Guided wave mechanics modeling for sensor development and process control in powder injection molding
74.	Powder Near-net Shaping Technology And Control Of Microstructure And Properties Of UNS S32707 Hyper-duplex Stainless Steel Parts
75.	Preparation And Properties Of TiC Reinforced 316L Stainless Steel By Metal Powder Injection Molding
76.	Research On The Technology Of Powder Injection Molding Of Ti6Al4V Alloy
77.	Numerical Simulation And Experimental Study On Powder Injection Molding Of Iron-Nickel Alloy Scope-base Parts
<<First <Prev Next> Last>> Jump to