cross-rolling - Globe Thesis

Keyword [cross-rolling] Result: 1 - 20 \| Page: 1 of 2
1.	Study On Microstructures And Textures Of Magnesium Alloy Deformed Plastically
2.	Non-symmetrical Cross-rolling Study
3.	Research On Gas Bulging Forming And Simulation Of AZ31B Magnesium Alloy Sheet
4.	Technology Research On Cross Rolling Of The AZ31 Magnesium Alloy
5.	Numerical Simulation Of Three Roll Cross Rolling Process On Hollow Drill Steel
6.	Study Of Deformation And Recrystallization Textures Of Cross-Rolled 3105 Aluminum Alloy
7.	Study On Shaping Law And Process Parameters Of Anchor Rod About Cross-rolling
8.	Research On The Three-roll Cross Rolling Forming Laws Of The Duplex Gear Blank
9.	Study To The Forming Process Of Composite Seamless Steel Tube Of Carbon Steel/Stainless Steel Piercing And Multiple Pass Rolling
10.	Forming Laws Research And Technology&Equipment Design For Rolling Processing Of Complex Deep-groove Ring
11.	Skew Rolling Modeling Based On Fuzzy Neural Network Research
12.	The Quenched And Tempered Process And Surface Rolling Reinforcement Of42CrMo Yoke Bars
13.	Research On Cold Stamping Process And Performance Of Magnesium Alloy Sheets
14.	Process Of Forming A Micro-channel Integral Finned Tube Heat Pipe Cross Rolling
15.	Studies On Hot Deformation Behavior And Cross Rolling Of Molybdenum
16.	Research On The Corrosion Resistance Of Pure Magnesim Sheets Produced By Rolling
17.	Research On The Deformation And Microstructure Evolution Of Large-modulus Gear Using Cross Rolling With High Frequency Induction Heating Process
18.	Tailoring The Texture And Anisotropy Of A Mg-2Zn-2Gd Alloy Plates By Cross Rolling
19.	Influences Of Cold Rolling And Annealing On Formability Of HTCR 5052 Aluminum Alloy Sheets
20.	Numerical Simulation And Microstructure Study Of TC4 Titanium Alloy Bar Cross Rolling
<<First <Prev Next> Last>> Jump to