Font Size:
a
A
A
Keyword [thermal barrier coatings]
Result: 1 - 20 | Page: 1 of 3
1.
Eb Nano-structured On-the Pvd Zirconia Thermal Barrier Coatings Research
2.
Aircraft Engine Turbine Vane Thermal Barrier Coating Design And Experimental Research
3.
Research Of Sm
2
Zr
2
O
7
-NiCr
2
O
4
Thermal Barrier Coatings With High Emissivity
4.
Numerical Investigation On Heat Transfer Of Air-cooled Turbine Blade Structure
5.
Numerical Study On Blade Cooling Structure Modification Design Of High-pressure Turbine Rotor
6.
Application Research And Numerical Simulation Of Thermal Barrier Coatings In Cylinder Liner
7.
Design And Parametric Study Of Plasma Spray Torch In Internal Powder Injecting Mode
8.
Microstructure Research Of EB-PVD Thermal Barrier Coatings High-temperature Corroded By Volcanic Ash
9.
The Correlation Of Residual Stress In TGO With Interface Failure Of Thermal Barrier Coatings
10.
Finite Element Simulation On Thermal Stress Of A Turbine Blade With Thermal Barrier Coatings Considering Cooling Channels
11.
On The Measurement Of Residual Stress And Fracture Toughness Of Thermal Barrier Coatings Attack By CMAS Glassy Deposits
12.
Inverse Analysis Of Acoustic Emission Source Of The Damage In Thermal Barrier Coatings
13.
The Analysis Of Morphology Of Thermally Grown Oxide Influence On The Stress Field In A Turbine Blade With Thermal Barrier Coatings By Finite Element Modeling
14.
Intelligent Discrimination Of Failure Modes In Thermal Barrier Coatings Based On Acoustic Emission Signals Analysis
15.
Research On The Synthesis And Plasma Spraying Of Thermal Barrier Coating Material Lanthanum Zirconate
16.
The Mechanical Performance Parameters Determination And Analysis Of Thermal Barrier Coating Material Under The High Temperature
17.
Residual Stress Measurements Of Thermal Barrier Coating Systems By Hole-drilling Method With Digital Image Correlation Technique
18.
Study Of Erosion Behavior By Finite Element Method Based On The Real Microstructure Of APS-TBCs
19.
TEM Characterization And Analysis Of Microstructure Evolution Of EB-PVD YSZ Coating Sintered At 1200℃
20.
The Optimization Of Machining Gap Of SACE For Film Cooling Holes With TBCs And Experiments About Engraving Process
<<First
<Prev
Next>
Last>>
Jump to
