Font Size: a A A

Electrokinetic nitrate removal from porous media

Posted on:1997-01-09Degree:Ph.DType:Dissertation
University:The University of ArizonaCandidate:Fukumura, KazunariFull Text:PDF
GTID:1461390014482888Subject:Hydrology
Abstract/Summary:
Nitrate movement under simultaneous influence of hydraulic, electric and chemical gradients was investigated. A one-dimensional ion migration model was developed and compared with laboratory column experiments. Operation of subsurface drainage with an electrode was discussed as an application.; The ion transport equation was developed utilizing non-equilibrium thermodynamics. Onsager's reciprocal relations were applied to reduce the number of linear phenomenological coefficients that relate flux to driving forces. Then phenomenological coefficients were expressed using known or measurable physical, chemical and electrical properties of solute and porous media. Developed equations were numerically solved by the Integral Finite Difference Method in one dimension. The numerical results were validated with analytical solutions of simple boundary conditions as well as the results obtained from laboratory column experiments for two or three applied gradients.; Without water flow, nitrate concentration increased at the anode by 2.5 times after 100 hrs of 30 V application. Three initial concentrations, 10, 100 and 500 ppm NO{dollar}sb3{dollar}-N, were tested. A log normal relation between elapsed time and relative concentration increase at the anode was obtained.; Two flux rates (0.112 and 0.225 cm min{dollar}sp{lcub}-1{rcub}{dollar}), and three inflow concentrations (100, 500 and 1000 ppm NO{dollar}sb3{dollar}-N) were used to evaluate nitrate transport in the column. Nitrate concentration at the anode increased by 10 to 20% at the end of all experiments. However, the concentration in the column was same as inflow concentration.; The application of electrokinetic nitrate removal by installed subsurface drainage with on-off (no flow then flush out) operation is recommended over a continuous flow approach. The numerical model results showed very low flux rates (i.e. {dollar}2.68 times 10sp{lcub}-3{rcub}{dollar} cm min{dollar}sp{lcub}-1{rcub}{dollar}) are required for nitrate accumulation in a sand column, and the experimental results confirmed no accumulation at a flux rate of 0.112 cm min{dollar}sp{lcub}-1{rcub}{dollar}.
Keywords/Search Tags:Nitrate, Cm min{dollar}sp{lcub}-1{rcub}{dollar}, Column, Flux, Results
Related items