| The ASTM C157 free shrinkage test is used to evaluate the effects of mix proportioning parameters and curing on concrete shrinkage with the goal of providing recommendations that will reduce concrete shrinkage in bridge decks. Specimens are dried up to 365 days at 23 +/- 2° C (73 +/- 3° F) and 50 +/- 4 percent relative humidity. Parameters include aggregate content; cement fineness; water-cement ratio; curing period; partial cement replacement by slag, Class C fly ash, or silica fume; superplasticizer dosage; the use of a shrinkage reducing admixture; and aggregate type.;The results indicate that increasing the aggregate content (decreasing the paste content) of a concrete mix decreases shrinkage and that water-cement ratio has little effect in and of itself. For a given aggregate content and water-cement ratio, concretes made with Type I/II cement shrink more than concretes made with Type II coarse-ground cement. Concrete containing a 30 percent cement replacement (by volume) of either Class C fly ash or granulated ground blast-furnace slag exhibit higher shrinkage than concrete with only Type I/II cement when cured for three days. Limestone coarse aggregate produces concrete with higher shrinkage than concrete made with quartzite coarse aggregate. Increased curing periods lead to a decrease in shrinkage for concretes made with either Type I/II or Type II coarse-ground cement. No consistent effect of dosage rate on shrinkage was observed for concretes made with the superplasticizers tested. The use of a shrinkage reducing admixture at a dosage rate of 2 percent by weight of cement reduced the shrinkage of concrete nearly32 percent after 365 days. The shrinkage reducing admixture, however, produced concrete that at times exhibited an unstable air content.;Keywords: aggregates, cement fineness, concrete, cracking, curing, fly ash, paste content, shrinkage, silica fume, slag, superplasticizers, free shrinkage, shrinkage-reducing admixture... |
