| The identification of the phase responsible for hydrodesulfurization (HDS) activity has been the subject of extensive research. In this study, model solid state catalysts prepared from elemental starting materials were synthesized, characterized, and then used to desulfurize thiophene at temperatures ranging from 200-400{dollar}spcirc{dollar}C and a pressure of one atmosphere.; The results of this work indicate that an increased HDS activity can be correlated with the presence of a poorly crystalline molybdenum sulfide-like phase detected by XRD, HREM, or AEM. The formation of this sulfur-deficient, non-stoichiometric phase could be accomplished by either removing sulfur directly from the catalyst synthesis mixture to yield a non-stoichiometric MoS{dollar}sb{lcub}rm 2-x{rcub}{dollar} moiety, or by introducing a transition metal promoter such as Fe, Co, Ni, or Cu into the system. The promoter atoms induced structural changes in the molybdenum sulfide edge planes by effectively scavenging sulfur during catalyst synthesis to form promoter sulfide species, which enhanced the formation of a non-stoichiometric, highly active molybdenum sulfide. This morphological effect was the primary function of the promoter in this system.; All model catalysts displayed similar structure in the (0002) basal plane of MoS{dollar}sb2{dollar}; however, only the catalytically active samples showed a high concentration of defects and disorder in the (1010), (1011), and (1012) edge planes. The HREM images obtained from these edge planes and their correlation with HDS activity dramatically illustrated the importance of the often-discussed edge plane structure of MoS{dollar}sb2{dollar} and its significance on HDS catalysis.; Normalization of the HDS activities for the solid state models and a commercial catalyst with O{dollar}sb2{dollar} or CO chemisorption uptakes suggested that a similarity may exist between the catalytically active sites of these materials. In-situ XPS revealed that increasing promoter atom concentrations resulted in a more complete reduction of the promoter atom; but this shift to lower binding energies could not necessarily be correlated with activity. However, it was observed that the more active catalysts all exhibited the ability to dissociate H{dollar}sb2{dollar} and remove oxygen from their surface. This H{dollar}sb2{dollar} spillover or activation may also influence catalyst performance. |
