| The goal of this research was to investigate the fluid dynamic and thermal performance of various nanofluids. Nanofluids are dispersions of metallic nanometer size particles (<100 nm) into the base fluids. The choice of base fluid is an ethylene or propylene glycol and water mixture in cold regions. Initially the rheological characterization of copper oxide (CuO) nanofluids in water and in propylene glycol was performed. Results revealed that higher concentrations of CuO nanoparticles (5 to 15%) in water exhibited time-independent pseudoplastic and shear-thinning behavior. Lower concentrations (1 to 6%) of CuO nanofluids in propylene glycol revealed that these nanofluids behaved as Newtonian fluids. Both nanofluids showed that viscosity decreased exponentially with increase in temperature. Subsequent correlations for viscosities as a function of volume concentration and temperature were developed.; Effects of different thermophysical properties on the Prandtl number of CuO, silicon dioxide (SiO2) and aluminum oxide (A12O 3) nanofluids were investigated. Results showed that the Prandtl number increased with increasing volume concentrations, which in turn increased the heat transfer coefficients of the nanofluids.; Various nanofluids were compared for their heat transfer rates based on the Mouromtseff number, which is a Figure of Merit for heat transfer fluids. From this analysis, the optimal concentrations of nanoparticles in base fluids were found for CuO-water nanofluids.; Experiments were performed to investigate the convective heat transfer enhancement and pressure loss of CuO, SiO2 and A12O 3 nanofluids in the turbulent regime. The increases in heat transfer coefficient by nanofluids for various volume concentrations compared to the base fluid were determined. Pressure loss was observed to increase with nanoparticle volume concentration. It was observed that an increase in particle diameter increased the heat transfer coefficient.; Calculations showed that application of nanofluids in heat exchangers in buildings could result in volumetric flow reduction, reduction in the mass flow rate and size, and pumping power savings.; Experiments on a diesel electric generator with nanofluids showed a reduction of cogeneration efficiency due to the decrease in specific heat compared to the base fluids. However, it was found that the efficiency of the waste heat recovery heat exchanger increased for nanofluids. |
