The Parametric Design And Research Of E·P Based On APDL And Command Flow

E·P is an major environmental equipment for the environment protection, and it also has a very important significance in making dust emissions consistent with the relevant state standards ,ensuring the public health and the achievement of sustainable development.The traditional design methodology of E·P is to have a simply checking and calculating of its strength and rigidity by material mechanics method after determining the basic structure type and the size of electric field. The general way to solve the problem such as the stress concentration is by improving the safety factor, which will inevitably lead to the E?P structure being conservative; Because of E·P's excessive size and complex structure, the investment budget is high, and material costs has a big proportion in the whole investment, so the conservative design will make the total project cost increase a lot.In recent years, with increasingly widespread use of FEM, many E·P production enterprises have used this method in the analysis and calculation, which greatly increased the design accuracy and reduce unnecessary material consumption, thereby reducing the cost. However, It will spend a lot of time on completing an analysis of the E·P, because the E·P is too large and too complex. Most of the time is spent on the fore treatment, such as model building, Boolean calculation and giving attributes. So the design cycle has been lengthened, and the market response speed and competitive power were reduced.In order to improve the design efficiency and increase their market competitiveness, Parametric Design can be used on the same cross-section E?P type after the initial size parameters are established. The required initial E?P structure models can be produced rapidly, and the stress field and displacement field can be got by using the three-dimensional FEM in the analysis of the structure, then make an analytical judgment on the irrational part by the strength theory, if the result is not in reason, modify and calculate the corresponding parameters repeatedly until the required structure is got. The whole process indicated that the parametric design method is a good way.Paper presented APDL (ANSYS parameters design language), order flow and structural characteristics of E·P, based on which it discussed the parametric design method and Boolean operations, and wrote the parametric program of E·P. At the same time wrote parameter input interface software under Windows operating system...