The Analysis, Based On The Development Of Its Mechanical Simulation Of The Plc Nickel Anode Plate Cleaning Machine

The Cleaning Machine of Nickel Anode Plate is an automatic machine device that is applied especially in cleaning the mud on the Nickel Anode Plate. In the process of electrolyze nickel, a great deal of anode mud adhere the nickel anode plate, which severe influence production efficiency of the electrolyzing nickel, but manual cleaning efficiency is so low that had fall back on the automatic machine device. The text is start at the need of practical manufacture, then formulize all the process of design and manufacture the Cleaning Machine of Nickel Anode Plate, including design scheme, program projection, draw detail drawing, elaborate and equip parts, assemble equipment, arrangement of wires and debug system. Comprehensive use many theoretics and knowledge, such as mechanical equipment design, CAD technology, Programmable Logical Controller (PLC), mechanical system simulation and other applied softwares. The final aim is design and assemble an armamentarium that can clean the anode mud on the Nickel Anode Plate.The text is made of four parts. Firstly, the start point is how to design the mechanical parts of the Cleaning Machine of Nickel Anode Plate, meticulous formulize the thinking of design the Cleaning Machine, principal analyze how to choose and assemble the parts of the Cleaning Machine, then careful calculate and check every main parts. Secondly, based on the control by PLC, narrate the choice of every control device and the equipment control principle, assemble the schematic circuit, set the control parameters and programming the control program. Thirdly, use the building model software, namely SolidWorks, to build every part of the equipment in the computer, then virtual assemble the general architecture in the computer, not only to check and judge whether or not have the interferences, but also can revise the mistakes in on the course of design and assemble the equipment. Then transfer the mode to ADAMS through the interface module software— MECHANISM/Pro, implement the simulation, including dynamic simulation for spring mechanism and vibratory simulation for single long shaft. At last give a summary about main characteristics of the equipment and private notions of improvement and optimization about the frame slide mechanism and drive shafts in the equipment.