| Our country put forward the slogan of building conservation-oriented society, advocating a concept of energy-saving, environmental protection life. At the request of the national policy, the construction industry began to explore with solar energy as heat source, to solve residents living in hot water. Solar energy is a renewable green energy, in the process of use, it does not produce harmful gases and polluting the environment.Otherway, it is inexhaustible. Therefore, the solar water heater as a new kind of green product used in residential construction, in order to satisfy the demands of residents living hot water has become a way for the development of housing construction industry. At present, the solar water heater is often as a rear equipment installed on the residential construction, simple installation, distributed disorderly, and safety measures is not sound, also bring a bad influence to city and the security of household. Therefore, In order to solve the above problems,this article mainly studies Installation Structure and application of flat-plate solar collector with building-integral. Thesis’s research content and the main work is as follows:1、 Analyzed the present situation of solar collector with building-integral, has been clear about the function and meaning of solar collector with building-integral.2、This paper expounds the design and installation of the solar water heater system, and draw the design and installation drawings by CAD software. Through the theoretical data, proved that the change of collector Angle can improve the influence of solar energy utilization, and designed a kind of balcony type solar collector installation, and collector Angle can be adjusted conveniently, can effectively improve that the utilization rate of solar energy to further meet the needs of people’s living hot water;3、Take Guangzhou area as an example, by focusing on sets combined with scattered set hot run way for people to provide living hot water, expounded the operation mode of the system structure principle and installation by CAD drawings, can solve the problem that on the roof of high-rise residential the heating area is insufficient. |
PDF Full Text Request