Research And Development Of A Real-time Monitoring System For Medical Monitor Running Status And Electrical Parameters Based On Zigbee

Monitors as a hospital medical equipment which is indispensable. The detection ofelectrical parameter is important. Traditionally need the third-party equipment to testmonitor electrical parameters,which process is very trouble and easy to undetect. In thispaper, to achieve monitor electrical and other parameters in real-time monitoring throughZigbee wireless network. Zigbee is a short-range wireless communication protocol, itscharacteristics are low cost, low power consumption, simple networking. Using relationalwireless electronic device by the Zigbee protocol and in accordance with the relevanttopology to set up a network, which name is Zigbee wireless communication network. In thisnetwork can CC2530and Zigbee protocol to design the Wireless RF Module, which arm isto set up one Zigbee wireless communication network. Obtain real-time monitor of thegoal’s mobile and the communication management.Firstly, this article made a brief introduction by giving a sample introduction of domesticmedical monitor condition and electrical safety. By make a comparison of others wirelesscommunication technologies and the analysis of actual demand, then elaborate the advantageof Zigbee Wireless communication technology. At the same time, this article give a detailedintroduction about network topology and stack of Zigbee.Secondly, we use the chip CC2530design the Zigbee module, and make an embeddeddesign about a part of electrical safety of the medical monitor principle picture. Then achievethe function that get the target location by Combining with the algorithm of RSSI and sanbian.After this, using the way of look-up table, we make a matrix which save the attenuationcoefficient between base stations achieving optimization of location.Then, this paper use C Sharp language to design the client software. which giveequipment management, map loader, alarm information statistical inquiry and dynamicreal-time monitoring to set up a simple and convenience Human Machine Interface.Finally, after the relevant tests. The electrical safety alarms and medical monitorslocating have a good result. The communications capability reach the demand of real time,fasting, stability and Security Basically.