Simulation Of Facility Plan Based On The Cell Manufacture

Facility plan is a reasonable identification of the specific location of variety of production equipment and devices. Equipment planning and design work in production line is an important part of Technology sector, the excellent facilities plan is of great significance for a newly established or modified production line and has very realistic meaningfulness to promote efficiency, reduce production costs, reduce labor intensity and improve equipment life and the quality of processing parts. Therefore, regardless of the establishment of new production lines, or transformation of the old production lines, the equipment should be reasonably planned. At the same time, the production mode in enterprises with the development of the manufacturing sector changes gradually from hand-to workshops lines to mass production methods, and to more flexible production units, in which many changes are involved. Gradual changes in the mode of production process, production equipment should also be in line with the mode of production.According to the characteristics of the current enterprises'production mode This article is to integrate facility plan in production line with the production mode in enterprises and to use Arena to construct the system to carry on the simulation modeling. In the process of Modeling and Simulation the requirements on the model itself should not only be considered and it is also necessary to test results more than once, this changes is reflected in the technical level of the modeling method and at the same time in the requirements on the modeling process model and configuration management. In the process of Production Line Simulation Modeling, the computer simulation has been an indispensable tool and in losses reduction, costs saving, development cycles shortening, equipment utilization improvement it plays an important role. The increasingly fierce competition in the Manufacturing industry urges various countries to make develop and apply the advanced technique of manufacture. Simultaneously the development and the application of the advanced technique of manufacture provides the new platform and sets higher requests for computer simulation's application. This article sums up simulation system's application in production facility plan under the cellular production way, has established simulation system of facility plan in the production line. According to the selection of different parameters we get the simulational testing data. In the tentative data we find three representative groups to compare with each other. Then found the planning of equipment in the reasonable model. Meanwhile It has prompted the system optimization plan by model analysis on equipment's efficiency in the system. The hope has some reference value through this article introduction to the emulation technique in the equipment plan's application...