Design And Realization Of Oil Fracturing Proppant Automatic Feed Control System

In view of the present domestic use more fracturing ceramsite, quartz sand, but their strength is low, can only be used for shallow oil well production. If the proppant used in deep well, it would be difficult to bear rock pressure and formation of various corrosion environment, a lot of broken, the broken rate is in commonly15%-25%, but stop oil outflow, to meet the requirements of the oil Wells of the situation, this paper proposes to use different main materials proportion on the quality of the products affected.On the analysis of the oil fracturing support agent production process on the basis of production control system for the following five aspects of improvement:the car walks control combination positioning technology; Feed water tracking automatic granulation technology; A pair of two automatic allocation blanking technology; The output tracking system control; The dynamic continuous system, improve the product grade and percent of pass.The system should be material water tracking automatic granulation technology, will oil proppant manufacturing process optimized, in order to achieve the optimization of water system architecture, which reduces the consumption, improve the production efficiency, yield increased significantly, the effective use of the mineral resources. USES the advanced powder/primers car walking control combination positioning technology and material water tracking automatic granulation technology, not only ensure the full use of energy to achieve the goal of energy saving, and can make the whole system to realize full automatic operation, saving production time and reduce the manpower, mineral resources, water and other production cost and improve the oil yield and quality of proppant.