Design And Implementation Of GPS Vehicle Location And Monitoring System

The transportation industry with the rapid social and economic development and progress, but because of the relative lag of highway construction, causing the traffic congestion, frequent accidents, need to rely on other ways to meet the growing needs of transportation. The introduction and application of the vehicle monitoring system, through the positioning of the vehicle monitoring, remote control, the transport vehicle used fully, reasonable, improve the utilization rate of.The thesis gives an introduction of the technology that is applied. They are the Global Position System (GPS), the General Packet Radio Service (GPRS), the Geographic Information System (GIS) technology, the single chip and the watching center of B/C mode. The system contains two important parts:the centralized watching center and the mobile terminals, and they were described from the element of hardware and the design and implementation of software. Then this system has its own special signal detection to satisfy the specified requirements. When the lid of oil tank is opened, the van is discharging and surveys discharge quantity. These informations are detected from sensors that were installed in different position. This system is exploited in view of the actual requirement, which realize the complete monitoring, control function for physical distribution fleet. At the same time, it has a low cost for developer.