Analysis On The Influence Of Jiangsu Province 's Manufacturing Structure Optimization On Economic Growth

Since the reform and opening up, China’s economy is in a state of long-term growth, the average annual growth rate of the gross production of more than 9% of the national economy, people’s living standard has been greatly improved. But in recent years, long-term exposure of industrial structure gradually emerged (including the allocation of resources is unreasonable, scattered industrial organization and other issues), increasing downward pressure on economic growth. Therefore, it is an urgent need to adjust the industrial structure to maintain a sustained and stable economic development. Usually rapid economic growth and the secondary industry, especially the rapid growth of the manufacturing sector linked to the manufacturing sector is essential for economic growth and development. Currently scholars focused primarily affect industrial structure optimization between research on economic growth, but few studies as an important part of the industrial structure, optimize manufacturing structure effect on economic growth.This paper focuses on the impact the issue of manufacturing structural optimization of the economic growth in Jiangsu Province were analyzed. Half of the article before the theoretical basis of this paper is mainly needed. First of manufacturing structural optimization connotation defined and further rationalization of the two dimensions of the structure and the structure of high-class manufacturing structure to measure the degree of optimization; then introduces the theory of economic growth in the manufacturing structure optimization; and finally from the allocation of resources, industrial linkage, the leading industry choice and industry organizations to analyze these four aspects of manufacturing structural optimum path of economic growth.The latter part of the article is mainly empirical analysis of how to optimize manufacturing structure in Jiangsu Province on Economic Growth. By describing the manufacturing structure optimization in Jiangsu Province and the state of economic growth, inferred optimized manufacturing structure in Jiangsu Province on Economic Growth of reason and empirical analysis, to verify this speculation. Specific performance optimized manufacturing structure affect economic growth as:whether long-term or short-term, high-class manufacturing structure can promote economic growth, internal high-class role in promoting more obvious; the impact of rationalization of manufacturing more complex structure of the economy, in lower economic output stage, manufacturing rationalization has a negative effect on economic growth, but large, manufacturing rationalization structural economic output and promote economic growth.Depending on the cause insufficient manufacturing structure optimization in Jiangsu Province and its role in the current process of economic growth failed to take full advantage of, the article finally gives some suggestions. In a further advance manufacturing structure inherent in Jiangsu Province on the basis of high-class and rationalization, to give full attention to the interaction between structure and manufacturing high-class manufacturing rationalization of the structure. In the process of economic development, not only to promote the high-class manufacturing structure, more structure to manufacturing rationalization on a more important position than ever.