Research On Furniture Enterprises Production Plan Based On Direct Labor Cost Control

Custom closet core competence lies in the production of a flexible production. Products are complex, but the production was able to high efficiency, low cost, short production cycle is completed. In this paper, the use of group technology to develop production plans, group research custom closet plate color, thickness, and parts of the processing sequence, but with the non-group comparison of production capacity, the following conclusions:(1) Sheet color factor for the Conference Board and Edge processes affecting productivity significantly, step for step edge capacity significantly affected specific data into daily capacity of 262.3 square meters of flat, the total production time reduction three links 14.46%, 18.72% lower direct labor costs;(2) The Conference Board areas: production status under a group, the Conference Board area and the relationship between the processing time for :: y = 0.0036x2-0.3366 x + 96.042, R2 = 0.9412, unit production time squared difference 25.015 s, production time per unit area reduction of 21.8%. Direct labor cost difference 0.319 yuan.(3) Edge components: unit square time consuming 19.68 percent decrease. Direct labor costs to a group of formula plan is 1.46 yuan / m2, the non-group plans 1.84 yuan / m2. Unit sqm direct labor cost difference 0.38 yuan.(4) Drilling areas: Production Comparison Group production orders, production time board member of the lower unit 1.688%, the effect is not obvious, because the selection of equipment for CNC machining centers, no large differences mode of production;(5) A group of factors, the most important color and process flow. Where the bulk of the most important single color and edge to the Conference Board. The refinement process flow effect for equipment processes decentralized obvious.